Jump to content

Changing a TV on a Leaf HDMI Matrix

Featured Replies

Posted

Should I power down the Leaf matrix before changing a TV that's connected to it? I'm essentially disconnecting the HDMI and ethernet cables (from the balun to the TV, not the network switch to the balun).

  • Community Expert
1 hour ago, dentalben said:

Should I power down the Leaf matrix before changing a TV that's connected to it? I'm essentially disconnecting the HDMI and ethernet cables (from the balun to the TV, not the network switch to the balun).

 

Yes.

Any HDBaseT connection (that carries power) creates a risk wehn unplugging, and while you technically may not need to disconnect that, it's just smart to unplug the matrix briefly, then back in when you're done.

  • 5 weeks later...

Make sure binding are first done then re run calibration! Make sure you connect it when all equipment is OFF as the HdBase-T devices are more sensitive than a baloon and they cost a fortune $345 MSRP. Ebay has some for $149 (second hand so make sure you have proof they work)

Check the specs of the TV if you have EDID (think thats the right acronym, good to turn on as the Tv communicates its capabilities to the matrix and provides best config.

They equipment is awesome just some little things like the baluns. 

Archived

This topic is now archived and is closed to further replies.

Important Information

By using this site, you agree to our Terms of Use.