jsimon77 Posted April 19, 2015 Share Posted April 19, 2015 Since the recent update to the software all of my zones are very loud even at the lowers setting. So even at Level 1 it's pretty loud. Can someone tell me in Home Edition how I adjust this so that level 1 is nice and quiet? Thanks! Jason Link to comment Share on other sites More sharing options...
Matt Lowe Posted April 19, 2015 Share Posted April 19, 2015 what is amplifying the speakers?anything else not on the same amplifier having the same problem?even though it indicates 1% can you continue holding the volume down to see if it gets quieter? Link to comment Share on other sites More sharing options...
jsimon77 Posted April 20, 2015 Author Share Posted April 20, 2015 I'm running an 8 channel and a 4 channel Control4 Amp controlled via C4 matrix. I remember at one point I was able to adjust this but I can't find it. When set to 0 it is off and muted. 1 is what it should be a 7 or 8. Thanks for any help. Link to comment Share on other sites More sharing options...
Cyknight Posted April 20, 2015 Share Posted April 20, 2015 What C4 amp - powerapm (no screen on the front) or matrix amplifier (little screen on the right hand side) Link to comment Share on other sites More sharing options...
jsimon77 Posted April 20, 2015 Author Share Posted April 20, 2015 Must be the power amps as there are no screens. Link to comment Share on other sites More sharing options...
jsimon77 Posted April 20, 2015 Author Share Posted April 20, 2015 I think I found it...Under audio switch I can adjust each channel. Link to comment Share on other sites More sharing options...
Cyknight Posted April 20, 2015 Share Posted April 20, 2015 Yep - if it's the powerapms, the update possibly reset the source level info. You can alos check the back of the poweramps - there's an input sensitiviy adjuster (manual 'screw') that also influences the inpult level as well, but take care adjusting those as taking that down could mean slower turn on time, occasionally could mean turning off at low levels (if the amp is used in 'auto' mode, ie not controlled via relay. Link to comment Share on other sites More sharing options...
jsimon77 Posted April 20, 2015 Author Share Posted April 20, 2015 They all jumped up with 10db. I brought then all back down to 1.75db. Still might be a bit much. I'm going to play with it. Is there any easy way to tell which input source I'm controlling. They are not named just numbered. Link to comment Share on other sites More sharing options...
lippavisual Posted April 20, 2015 Share Posted April 20, 2015 the numbers correlate to the numbered outputs Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.