How to integrate an RF-controlled device?

[DLite]

We have two Bromic Patio heaters that use RF remotes. The specs say the remotes use 916 Mhz as their frequency.  From what I understand, this lies outside the range of frequencies compatible with Bond Bridge. Are there any other alternatives to Bond bridge out there that would let us integrate the RF control of this device into Control4?

Thanks!

[Matt Lowe]

check out the matterlink. It maybe capable of what you need.

[alanchow]

4 hours ago, Matt Lowe said:

check out the matterlink. It maybe capable of what you need.

Matterlink is only 315/433mhz RF.

Bond Bridge is 300-450mhz RF

[DLite]

17 minutes ago, alanchow said:

Matterlink is only 315/433mhz RF.

Bond Bridge is 300-450mhz RF

Too bad.  I had gotten excited about Matterlink for a minute!

Thanks for the clarification.