hey @jackstone, your recommendations and solutions, not to mention the driver(s), have been working wonderfully so far! however, i have finally run into an issue i'm confused by
for reference, i'm using the response box (which now comes with both an XLR-3 and an XLR-5 output, and they have told me they're outputting the same commands to both XLR outputs. i have recently purchased some recessed indoor lighting (fwiw, coloronix 3" rgbw downlights). initially, i added on the decoder on the coloronix unit (built in) as the last daisy chain on my existing PX24500 decoder chain. there was no function. then, i connected the coloronix decoder to the existing XLR-5 output i'm using with the same cable, and getting a weird issue.
when i try and use your dimmer drivers, the light just flickers and is seemingly random, for hours. when i go to the RS232 DMX Engine driver and choose "all channels on" it works just fine. i have verified the light works as the decoder has a built in autonomous dmx engine that you can engage via various dip switch settings, and all function perfectly as well. additionally, i have installed a dmx terminator (home-made, 1/4w 120ohm resistor, tested on a calibrated fluke to 124ohm, shorting pins 1/2 on the RJ45 connector). i'm using high quality XLR to RJ45 cable, and it works just fine with the px24500 decoders on my outdoor lighting.
do you have any ideas or suggestions? these coloronix units are very high quality, and i've yet to contact the mfg (as it's saturday, and the light seems to work as it's supposed to, the hiccup is the driver). thanks in advance