AtlantaSteven
-
Posts
71 -
Joined
-
Last visited
Reputation Activity
-
AtlantaSteven reacted to msgreenf in Suddenly unable to access
that's caused you asked the right guy
-
AtlantaSteven got a reaction from msgreenf in Suddenly unable to access
rebooted and then removed and added system.
All set now.
-
AtlantaSteven reacted to Gary Leeds UK in Axis Gear
Yes done it a couple of times
When the Batteries start to go you will see them flash Red and get a bit and miss on Programming.
When we changed the batteries they were still connected to C4
-
AtlantaSteven got a reaction from tekki70 in Axis Gear
Hi, I finally connected my 6 Axis gears to C4.
I do have one issue that I wonder if others have seen this.
Once you configure the gears in smart home mode, then paired with C4, if you need to reconfigure the fully open/close points, you need to switch them make to native (non smart home) mode.
Then when you switch back to smart home mode, you loose connectivity with C4. You’ll need to contact your dealer/remote installer to re-pair them. I never had this issue when I used smart things as my automation hub.
Have you seen this with your setup? Can you try it?
thanks in advance.
-
AtlantaSteven got a reaction from zaphod in Does anyone here have experience converting manual roller shades to motorized ?
Mine is the same. When I purchased the Axis controllers they included several metal connectors that are the correct thickness. I used them to replace the connector on my plastic beads. Mine looks like your picture on the right. I didn’t need to cut my beads however. I assume you can cut it anywhere, remove 2-3 beads and then use the supplied metal connector.