tdougray

If you have the clipping light on try adjusting the sensitivity of that zone (gain).

24 minutes ago, Cyknight said:

Then again, for the cost involved....could just replace the non 4k TVs

You can’t replace the pioneer no matter what the cost! That’s just plain wrong

Does the rechargeable battery and cover from a sr250 fit an sr260?

Ignore Mitch, just re-read your post

16 minutes ago, msgreenf said:

nope, if use theauxiliaryy switches not keypads in the other parts of a 4-way or 3-way everything still works

Oh my mistake Mitch, I didn’t think keypads would work unless a project was up and running.

11 hours ago, nate4AU said:

Follow-up (stupid) question: so what happens to all these automated lights if the system goes down for some reason? Do you lose the ability to turn on your lights until the problem gets fixed?

On the wireless front I believe the main dimmer connected to the load will work just as a dumb dimmer even without c4 (bloody expensive dumb dimmer mind ) but all keypads/ programming associated will not work until fixed. 

25 minutes ago, msgreenf said:

Speaker point is junk. Don't buy it

Lmfao Not a fan Mitch! 
Love this no nonsense  review

56 minutes ago, drmark12pa said:

 

Does this amp need any connection directly to an audio source or does it stream via Cat5 or wireless?

 

Doesn’t need connection to an audio source as it has its own audio stream built in.

11 minutes ago, chopedogg88 said:

@tdougray $4k?  is that Canadian?

MSRPs are:

Triad 8x8 = $1320

Triad 8-zone power amp = $1700

So, $3020 at MSRP (minus any discounting...)

No just my stupid fingers,  I was just trying to say that a fix for his existing setup could be less than $100. A lot less than even 3k but yes your quite right . Soz

Above is a great replacement but If you’d rather not spend 4K out I would recommend taking the amp to an electrical specialist. It can be a cheap fix and sometimes a heat related problem where basically the heat sink just isn’t big enough and the linear regulator chip fails. It’s a real shame because the build quality is amazing but just seems like getting the heat away was an after thought. 

1 hour ago, JSTRONG said:

 

Or just send ir commands and try different ports  to find the flash 

 

Exactly this and label them at the same time

10 minutes ago, Cyknight said:

(Britain being the exception),

Why have we always got to be the exception (and mostly means less good stuff available) 

16 minutes ago, Nehsmit said:

I meant with the actual Alexa remote. 

Isn’t that your voice?? 

https://www.blackwiredesigns.com/cat/automation-apps-and-drivers/control4_drivers/surveillance_cat/

4 minutes ago, LollerAgent said:

Use the Room Control driver.  It's simple.

can you select radio stations on the presets?

19 minutes ago, moreno5uk said:

Oh that's annoying, I only need a few buttons done and my dealer charges £65 for what is about 8 mins work.

There are plenty of good guys on here who can remote in to do this. If you want someone in the UK give @Crustyloafer a message. He'll look after you.

10 minutes ago, Newbie4 said:

 

I am becoming a UK dealer, my application just got accepted and they just sent of the first proposal of what I must buy to start the training

 

Gotcha And best of luck. Need more dealers here in the UK.
 

I’m sure I must of read this wrong, are you saying you’ve become a uk dealer without knowing the difference between an EA1 and a EA5? 
 

or are you looking to become one? 

Oh no !!! Lights and switches

Have you experienced any major problems with Wi-Fi and I take it it’s the “roku premier “ you’d suggest?

or +?

50 minutes ago, Crustyloafer said:

totally understand the reluctance to use a Wi-Fi only device.

55 minutes ago, Crustyloafer said:

I'm in the UK and my Roku has both the Amazon Prime and Disney+ apps,

Would you always prefer to use Roku over a TVs mini apps? Looked at going over to it but in the UK it’s over wi-fi only which sort of put me off. 

you need a driver but philips hue motion are cheap and work well.

Have you re-synced the app? I think it’s called “sync settings”

3 hours ago, CesarHinde said:

but it is by far crap or flakey when set up properly.
 

About 2 yrs too late

im I’m sure there should be a “not” in there Somewhere

55 minutes ago, Cyknight said:

And where they'll need to be replaced for sure. Get those out.

So what would you recommend for waps? Ie would you endorse unifi’s?