dentalben Posted May 12, 2015 Posted May 12, 2015 Anyone have a source for BenQ projector drivers? All I see in Composer is for the W10000 which is 7 years post-production. Probably still compatible with IR codes, but I'd like to have at least a somewhat newer driver.
alanchow Posted May 12, 2015 Posted May 12, 2015 Here is a quick one way RS232 driver i made up for the BenQ W1070/W1080ST projector. It may work with other models but i have not tested it.
vstar Posted January 19, 2016 Posted January 19, 2016 On 5/12/2015 at 6:35 PM, alanchow said: Here is a quick one way RS232 driver i made up for the BenQ W1070/W1080ST projector. It may work with other models but i have not tested it. Thank you very much for this Alan, picked up a w1070 last week and this driver works like a charm. my only mistake and it was totally my fault was i changed the default baud rate on the projector when i was doing initial projector setup prior to my control4 integration thinking 9600 was more common for drivers and of course the driver could not communicate so i put it back to 11520 and it immediately started working. Thanks again.
alanchow Posted January 20, 2016 Posted January 20, 2016 4 hours ago, vstar said: Thank you very much for this Alan, picked up a w1070 last week and this driver works like a charm. my only mistake and it was totally my fault was i changed the default baud rate on the projector when i was doing initial projector setup prior to my control4 integration thinking 9600 was more common for drivers and of course the driver could not communicate so i put it back to 11520 and it immediately started working. Thanks again. No problems. Driver only took a few minutes for me to create.
Alt Posted September 8, 2016 Posted September 8, 2016 Confirmed working on a new BenQ HT2050. Thanks Alan Btw to point out Pins 2 and 3 are reversed on the DB9 connection to the projector.
alanchow Posted September 8, 2016 Posted September 8, 2016 2 hours ago, Alt said: Confirmed working on a new BenQ HT2050. Thanks Alan Btw to point out Pins 2 and 3 are reversed on the DB9 connection to the projector. No problems.
Harmeet Brar Posted July 6, 2017 Posted July 6, 2017 Hey guys, I have a Db9 Cable connected to the HT2050 Projector into serial 1 on my HC-800 do i need to reverse the Pin layout for 2 and 3? i also only have a Baud rate option of 115200 not 11520. any help would be great. Thanks!
alanchow Posted December 29, 2019 Posted December 29, 2019 12 minutes ago, Unickow said: Is there a driver for the Benq HT 3550? https://chowmain.squarespace.com/benq-control4
Recommended Posts
Archived
This topic is now archived and is closed to further replies.