Samsung TV won’t turn on with C4

[rf9000]

Guys,

So I just replaced a 85” Samsung QLED with an 85” Samsung QLED NEO. It’s on the network and functioning through Control4, except the fact that once it’s turned off it won’t turn back on again unless I unplug the TV. If I unplug the TV and plug back in, then hit “watch Roku” the TV immediately comes on and all works great. WIFi is turned off (because it’s hardwired), Power On with Mobile is enabled, and IP Remote is enabled. Any ideas?

[Topfox]

IP address conflict maybe? Maybe it “steals” as the primary but then overtime the conflicting devices “steals” it back. Just a guess. 
 

also good to note on Samsung devices there is like a 30 sec delay with power on/off. If you turn it off and then immediately try to turn it back on you have to wait 30 secs. 

[WhyPhy]

Do you have the correct MAC address entered into the driver to enable Wake On LAN?

[msgreenf]

34 minutes ago, WhyPhy said:

Do you have the correct MAC address entered into the driver to enable Wake On LAN?

Yes it's correct 

[msgreenf]

49 minutes ago, Topfox said:

IP address conflict maybe? Maybe it “steals” as the primary but then overtime the conflicting devices “steals” it back. Just a guess. 
 

also good to note on Samsung devices there is like a 30 sec delay with power on/off. If you turn it off and then immediately try to turn it back on you have to wait 30 secs. 

Told him the same thing ...