CardAccess mini-remote compatible with 2.8?

[dutsnekcirf]

I'm probably way late to the party here but I just got my automation system back up and running from a few years ago.  I was last on OS 2.1 and am now on 2.8.  I had a CardAccess mini-remote back then and haven't given it a try since.  Are these things still supported in 2.8?

I replaced the batteries and now it's just got a slow blinking green light.

[Cyknight]

Not sure on the light, but they ARE supported.

[nawty]

I have 2 in use and yes +1 supported....

[SMHarman]

I have 2 in use and yes +1 supported....

I also have 2 in use but wish they had a beep like the remotes. Love yo know where one of them is.

[SMHarman]

I replaced the batteries and now it's just got a slow blinking green light.

I've got the instructions at home will look over the weekend to find out what that means.

[nawty]

To remove the Mini Remote from a ZigBee PRO network and restore

factory settings:

1. Press Button 1 (top left) while installing batteries. The LED will

intially be green.

2. Continue pressing the button until the LED turns from green to blue.

3. Once the LED has turned blue, release Button 1 and press Button 4

(bottom right) within three (3) seconds.

4. The LED will turn solid red while the defaults are loaded.

5. The LED will turn solid green for approximately four (4) seconds and

then blink green for approximately seven (7) while the remote reboots.

6. The Remote is now restored to factory configuration

[Matt Lowe]

likely since the remote has been offline for sometime it lost its zigbee credentials.

 

repairing it should bring it back online