Scrib
c4Forums Member-
Posts
263 -
Joined
-
Last visited
Content Type
Profiles
Forums
Blogs
Gallery
Downloads
Events
Everything posted by Scrib
-
Is there any thought around adding local LAN control for the devices that support it vs. relying on cloud?
-
Disregard
-
20230522 and it was set to 60. Doing basic math, at 9 current devices with a 60 second polling rate, I'll run out in 18.5 hours. So yea, that's my problem. lol More coffee...
-
Currently have 6 Govee light bulbs, a LED strip, and some pathway and flood lights. And I'm looking to add another 3 sets of pathway and flood lights, each. I haven't paid much attention, but it seems I am rate limited in the morning, every morning. I don't think I have anything out of the ordinary in terms of driver config, so wondering if there is anything I need to do differently? The lightbulbs are in my kid's bathroom, on non-C4 switch, so when the switch is off, the bulbs are not connected to WiFi. LED strip, and outdoor lights are always on the network.
-
Ah, thank you!
-
Is there an issue with the driver this morning? Maybe something to do with a C4 service issue currently on-going (4/3/23)? I seem to have lost connection, wondering if it's a Govee thing, C4 thing, and/or me?
-
New firmware just got pushed? Looks like you can now turn off the room off confirmation.
-
Switched to AT&T Fiber, do I need to change setup?
Scrib replied to Smess's question in Question & Answer
While this is for Ubiquiti gear, it really would be for anything. Couple important steps to take. It's pretty easy. Important piece is ensuring you use the right MAC address for the gateway/router. https://spin.atomicobject.com/2021/02/19/ip-passthrough-bgw210-700/ -
Switched to AT&T Fiber, do I need to change setup?
Scrib replied to Smess's question in Question & Answer
Yea, if you have other infrastructure to do the routing and switching, you just need to put the 320 into bridge mode so it passes the WAN IP. Easy to do. Unfortunately, ATT has made it impossible to remove the 320 from the equation, so at a minimum you need it in bridge mode. Welcome to fiber. I don't miss Comcast one bit. -
Did you have UAPSD enabled prior to getting the remote online? Enabling that really enhanced battery life for me.
-
I pulled out my NX-8E for Qolsys and have been much more satisfied. So much easier to program, I've added water leak sensors, Smoke/CO2 tied back into Qyolsys. It's just easier for my residential needs.
-
Whoops. Ignore.
-
I just tried it, works for me. I didn't do anything on my side other than connect the Halo to the project.
-
How did you reboot it?
-
Very limited use. Anyone know how to power cycle the halo? Like to try and "restart" it and see. I've noticed the display is now staying on, all the time?
-
Ok, to weigh in on the battery performance, so far, not good. Down over 30% in just 4 hours. RSSI of -45, on 5GHZ and latest firmware.
-
Yea, that's it. Still issues with the handshake? I haven't had that issue, fortunately.
-
Anyone able to bring up the OSD with the Halo, after pushing the colored dot button in the bottom right and then pressing the "4"? I think that's how it's supposed to work, right?
-
Got mine yesterday, setup worked the first time. I'll keep an eye on battery life.
-
Try 1111 or 111100.
-
Wondering the same thing.
-
Any updated shipping dates for the non-touch?